Brought to you by Barnacle Bill's Marine Supply. (856) 785 9455

Sign up Latest Topics
 
 
 


Reply
  Author   Comment  
ExplorerE1

Registered:
Posts: 5
Reply with quote  #1 
2008 E50DSLSCS
Bought recently as non-runner with suspected EMM failure confirmed by my etec dealer & previous owner ran engine without issues until engine cut out on last trip & previous to this had fuse blow which his dealer advised was due to short/bad connection.Only 85 hours on printout & I am considering replacing with new/repaired EMM although a bit concerned at blowing out another EMM.
Any advice or checks to reduce this risk would be greatly appreciated.

PhilH12

Registered:
Posts: 3,499
Reply with quote  #2 
Maybe best to post up that engine report.

Meanwhile, I "think" the 2 major causes of EMM failure are Heat and Voltage spikes - like sparking battery chargers, loose electrical connections, etc.

That report may show some over heats or intermittent B+?

Phil

__________________
Always check the Easy Stuff First!
20' Weeres fishing pontoon
90 HP E-Tec E90DPLSUM  05184332
Lake Tawakoni, TX - Catfish Capital of Texas
ExplorerE1

Registered:
Posts: 5
Reply with quote  #3 
Thanks Phil & all paperwork still with dealer & will report back when receivec again.
Previous Topic | Next Topic
Print
Reply

Quick Navigation:

Easily create a Forum Website with Website Toolbox.

Disclaimer: Activities and modifications described or displayed on this message board and it's pages may be potentially dangerous. E-TEC Owners Group along with Barnacle Bills Marine does not endorse or make any claims to their safety or performance. Be sure a trained E-TEC service technician performs all your service work.